ALUMINUM PLATE PROCESSING

Various types of aluminum plate processing, aluminum cutting, and aluminum cutting. Please leave it to us for machining of aluminum, prototype aluminum parts such as machining, milling, lathe, drilling, complex shape machining.

In addition to machining and NC milling, which we are good at, we can handle aluminum polishing, wire electric discharge machining, etc. in a short time from one piece in cooperation with neighboring factories . Aluminum is a material suitable for weight reduction and miniaturization. We propose to reduce the weight by replacing with aluminum parts.

Case for electronic board

A2017 80x120x320

Inspection equipment parts

A5052 80x90x180
Surface accuracy is also important for parts that are cut into a spherical shape.

Communication equipment related parts

A5052 150 × 200 Thickness 20
Minimum blade diameter Φ0.5 Aluminum Using dozens of blades, it takes about 5 hours to cut one

Case for electronic board

A2017 80x120x320

Electronic board case

A5052 No treatment The lid is a heat sink

20 × 800 × 900mm
M6 tapped holes approximately 1100 locations

It is beyond the machining range of the machining center, but can be machined with our knowledge.

Communication equipment case

A5052 50×100×10

NEXCO Central Japan 2nd Tomei
Numazu SA Toilet Display Board

We produce only the aluminum plate at the tip. It is a cover that prevents the LED light from coming out.

Heatsink

Prototype Groove width 1.5 Depth 12 Number of grooves 28 Width 85 Depth 86 Thickness 18

Semiconductor plates

A5052 Guide plate for aligning workpieces
3×10 hole thickness 15mm

Amusement equipment

ABS & A5056 Drum prototype

Demonstration equipment for exhibition

Entrusted only to manufacture aluminum parts for fluid polishing machines (customer-developed products).

Screw machining using simultaneous 3-axis control of machining center

“I want to thread M80 × P1.5 on a large square workpiece.” It is impossible with a lathe and it is very expensive to buy a tap. Highly accurate and high quality screw machining is possible at low cost. There are many other benefits. Please contact us for details.

Analysis equipment

A5052 50 × 150 height 36
Used as a heater to heat a test tube containing 36 specimens in height . The groove width is 4mm and the depth is 40mm. Aluminum with excellent thermal conductivity. Copper has higher thermal conductivity, but aluminum is used because of its high material and poor workability.

Bicycle parts for competition

A2017 t8.0x40x50
Designed and 3D printed by the customer, then cut by our company after confirming the shape.

Communication equipment parts

Oxygen-free copper 20x42x125
It was quick delivery projects speed corresponding with the use of 3D data

Reducing delivery time and costs by proposing design changes

A5052 106x255x990
Work size close to MAX for in-house equipment. Manufactured by changing the machining part with an angle from the side to a design that allows machining from the top. Helisert inserted in about 50 places.